The ExpressPCB Community Library here! Share your custom components and projects with fellow engineers.All components in the community library are user created. Terms and Conditions.
Please contact firstname.lastname@example.org with any feedback or assistance.
DSUB 15 HD Female through hole connecor
AMP 15 Position Right Angle HD VGA connector. AMP Dwg # C-1734530
All components in the community library are user created. Use them at your own risk. ExpressPCB does not validate the accuracy or details of the components submitted by the user community.
Terms and Conditions
September 3, 2016 at 11:02 pm
Good alignment with pin centers. Through-holes for a typical DB15-HD straight or right angle connector are a bit oversize. This makes it easier to insert the 15 connector pins into the board, but the holes for the two large split-pins (from the shield) are so large that the part does not hold itself in place for soldering as intended.
September 4, 2016 at 9:38 am
The holes are large as you said the through pin holes are 1.8mm instead of the specs 1.19mm and the mounting holes are 6.35mm while the spec calls out 3.18mm. I made them large because I bought my connectors from China and wasn’t confidant of the Quality control. Better large than small. I did get the mounting too large and I noticed during assembly that I had to bend the retaining tabs to get them to stay in the holes.
August 21, 2017 at 6:56 pm
I have to say this isn’t very good. While the centers are correct, the holes are to large and there is no silkscreen to aid with part alignment or orientation.