ExpressPCB Forum

Forum Home

Back to ExpressPCB...

 

Connect error (1 reply and 3 comments)

Andrea
3 years ago
Andrea 3 years ago

When I run the Checking Schematic for netlist errors, I get the error "The selected corner is only connected to one wire. This indicates a wire that is not properly connected at both ends ... Check the wire and either delete it or drag the wire's end to the desired connection point (either a corner or component pin)"

 

I'm trying to connect a wire to a custom made component. No matter what I try, nothing seems to work - how do I create a connection to the component?

 

Thanks,

Andrea

ExpressPCB
3 years ago
ExpressPCB 3 years ago
Accepted answer

Hi Andrea,

Do you have a pin on the component where you are trying to connect the wire?

Andrea
3 years ago

Does both sides need pins? I have a pin connected to the body of the component

Andrea
3 years ago

I got it ... the pin was on the wrong end, it is supposed to be on the side furthest away from the part body

ExpressPCB
3 years ago

Good to hear you got it!

Back to ExpressPCB...